Getting Started with AutoQ3D CAD for Android
Getting Started with AutoQ3D CAD for Android
Launch AutoQ3D CAD in your AndroidTM mobile device
First press menu button followed by the Draw button then select the Rectangle button
Before we start to draw the rectangle touch the Snap button and then select the Grid option
Move the cursor to 0,0 position and keep touching the screen and then give a second touch to everywhere on drawing area to "click"
Move to coordinate 6,4 and make a second touch on drawing area to "click" to finish the Rectangle tool
Now touch the Snap button and select Endpoint option
Now we are going to draw an arc, press the menu button and select the draw option and then the arc tool
Now touch the screen to move the cursor to the position 6,4 and make a second touch on drawing area to "click".
Now set the second point, we are going to input the coordinates manually. Touch on instrutions(Top of screen) and will display the current options, and select ">>Value"
Ath this moment a keyboard will display o screen waiting for you to enter the value manually. Input "@-3,3", the "@" means It is a relative coordinate to the current point, then click OK.
Then select the third point moving the cursor on the endpoint and then make a second touch on drawing area to "click".
That will finish the "arc" comand, to erase the top line of rectangle, touch the screen and set the cursor with the small square pointing to the line and then make a second touch on drawing area to "click" and release the touch (Note: if you maintain touching the screen with the second input and then move the cursor then this will do a window select). To unselect or cancel the current command press <Esc> button.
Touch the "Top options" button and then select "erase"
Now we are going to do a round fillet. Press the menu button and select "Modify" and then fillet tool
Select the line setting the cursor small square over lower corner of line, and then make a second touch on drawing area to "click". Touch on instructions area to change the fillet radius, select "Radius".
Click again on instructions area and select ">>Value" and then the value 1
Then select the line setting the cursor small square over right side of line, and then make a second touch on drawing area to "click". Then click on <Esc> button and that will finish the fillet command